via Soorajece on instructables
In this tutorial, I go over how to integrate the EM-18 RFID Reader module with a Raspberry Pi board. I also show how to integrate an actuator, in this case an Relay, to respond to a correct reading from the RFID module. This actuator can be a solenoid lock, a speaker, or even a web interface that logs data.And also interface with a GSM module to give message notification. I discuss how this design can be implemented as an RFID smart lock.
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
No comments:
Post a Comment