Thursday, December 26, 2019

Venom Mask #3DThursday #3DPrinting

Featured preview 00000PORTRAIT 00000 BURST20191030225724923

Shared by MikeMasek on Thingiverse:

Venom Mask. Remixed from tombart’s Venom bust. Printing at this size will fit an adult, as you can see from the picture (large on my sons head).
This was done quickly. It could use a trimming here and there. A few areas are fairly thick. I suggest printing at the lowest infill possible. I think I printed it at either 10 or 15%. The pieces will need to be orientated in your slicer for best printing. Cura’s lay flat works very well.
Finished with fill primer, lots of sanding, and acrylic paints.

Download the files and learn more


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

No comments:

Post a Comment