via tonygo2 on instructables
This board provides makers with easy to use pick up points for 3V3 (2) and GND (9) in addition to each of the Grove ports (6). The back of the board shows a Pico pinout with pin connections for the SD card. There is also a track cut point with solder pads if you want to disable/enable the blue LEDs. With the Pico already soldered in place, the easy-to-use connections and the pre-wired components included; this board will appeal to many makers and especially those who are not confident with a soldering iron.
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
No comments:
Post a Comment