revere521 shares:
This is my Remix of the Mini UNTZtrument from Adafruit (https://www.thingiverse.com/thing:409733)
I added a ProMicro mount – since they have the Leonardo boot-loader and similar pin-out.
I also slimmed the case down a bit, since the micro is significantly smaller than the Leonardo was.
The only addition to the existing instructions (https://learn.adafruit.com/mini-untztrument-3d-printed-midi-controller/3d-printing) is to use the TeeOnArdu board library in the Arduino IDE
I included my sketch, but its unchanged from the one on the Adafruit site
download the files on: https://www.thingiverse.com/thing:4597617
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
No comments:
Post a Comment