JoeBowler shared this project on Thingiverse!
Snap fit Raspberry pi 4 case, no screws necessary. Basically a honeycomb venting style design. There’ s 3 types of tops. 1.) No slots or cutouts. 2.) Top with slots cutout. 3.) Top with slots punchouts that can be removed when needed.
The Raspberry pi 4 runs very hot and should be used with heatsinks on the chips. This minimal low profile design should be able to accomodate the heat sinks. I did not design a type with a vent or fan screw holes. The case is vented enough without a vent design. If one is sole desired I can add it upon request
Download files: https://www.thingiverse.com/thing:4677541
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
No comments:
Post a Comment