via AnghelutaA on instructables
For this,you will need:
-A raspberry pi(i used the raspberry pi 3B+ but you can use any pi excpt the zero and zero W)
-A 3D printer(for the case)
-A raspberry pi lcd (I used the Waveshare 2.8A for RPI)
-A cable to connect the pi to the lcd
-A micro SD card over 8GB
-A hot glue gun
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
No comments:
Post a Comment