We’ve got a new tutorial in the Learning System this week from Erin St. Blaine: how to solder headers. If you’ve been having fun with Gemma and Circuit Playground boards and are ready to level up to Adafruit’s Feather and FeatherWing lines with all their fancy features, this is a great place to start. This guide goes over proper soldering techniques for male, female, and stacking headers and also gives tips for de-soldering when things go wrong. From the guide:
Headers are like the duct tape of electronics. They’re great for connecting things together, soldering to perf-boards, or preparing boards for plug-in components like servos or sensors.
Using headers with your microcontroller can make your life much easier, but soldering them on can be a little intimidating to beginners. There are a lot of ways to get it wrong, and once a header is soldered onto a board it’s difficult or impossible to get it off again.
This guide will teach an easy and reliable way to attach your headers, with tips for getting them on straight and accurate, so you can move on with your project with confidence. It will also give advice about pitfalls to avoid, and what to do when you get them on wrong.
You might also enjoy a look through Adafruit’s Guide to Excellent Soldering, if you’re just getting started.
See the full tutorial here: https://learn.adafruit.com/how-to-solder-headers/overview
No comments:
Post a Comment