We’ve got the New nEw NEW for you right here:
NEW PRODUCTS THIS WEEK
Translucent Snap-on Case for micro:bit V2
This simple Translucent Snap-on Case is both good looking and tough enough to toss into your bookbag or toolbox. It has slim cut-outs for your cable, speaker, and battery. It’s translucent plastic so you can still easily see the micro:bit PCB markings and LEDs shining through. The bottom section is open so you can plug it into a micro:bit accessory.
Smoke Snap-on Case for micro:bit V2
This simple Smoke Snap-on Case is both good looking and tough enough to toss into your bookbag or toolbox. It has slim cut-outs for your cable, speaker, battery. It’s darkened plastic but you can still easily see the LEDs shining through. The bottom section is open so you can plug it into a micro:bit accessory.
GPIO Female Socket Riser Header – 2×2 4-pin
This 0.1mm pitch 2×2 Female Header is the perfect boost to use with boards that use the 4-pin ‘PoE’ header on the Raspberry Pi 3 and 4, like the Raspberry Pi PoE HAT! It’s a great pairing to the 2×20 socket riser header to get a full lift.
Adafruit Prop-Maker Starter Kit – Make your own Lightsaber!
Use the force and Adafruit Feather to build a battle-grade lightsaber! If you can’t make the hyperspeed jump to Ilum for your Jedi rite of passage, the Adafruit Prop-Maker Starter Kit is perfect for making your very own 3D-printed NeoPixel Lightsaber. It contains practically everything but the khyber crystal!
Adafruit CYBERDECK Bonnet for Raspberry Pi 400
Howdy keyboard cowboys, are you surfing the information superhighway with a Pi 400? Want a cool heads-up display, or maybe you need to wire up some NeoPixel wetware…?
Adafruit CYBERDECK HAT for Raspberry Pi 400
Cyber-warriors, listen up here! We’ve got with some zero-day unreleased hardware we just dumpster-dived. Now you can crack kodes, and write skripts with style, thanks to the CYBERDECK HAT for Raspberry Pi 400 from Adafruit zaibatsu.
40 Pin GPIO Extension Cable for any 2×20 Pin Raspberry Pi – 150mm / 6″ long
That new Raspberry Pi 400 computer you just got has a row of 2×20 pin headers on the right side – those are the GPIO (general purpose input/output) pins, and for those of us who like to hack electronics, they are where the real fun lies. By programming the Pi, you can twiddle those pins high or low, send and receive I2C and SPI data, and access the 3V and 5V power rails.
Adafruit LTR390 UV Light Sensor – STEMMA QT / Qwiic
The LTR390 is one of the few low-cost UV sensors available, and it’s a pretty nice one! With both ambient light and UVA sensing with a peak spectral response between 300 and 350nm. You can use it for measuring how much sun you can get before needing to covering up.
New Products 12/31/2020 featuring Adafruit LTR390 UV Light Sensor – STEMMA QT / Qwiic!
Visit www.adafruit.com/new for more info.
No comments:
Post a Comment