Thursday, September 30, 2021

Potty / Toilet Pet Water Bowl – Auto Filling! #3DPrinting #3DThursday

Potty Toilet Pet Water Bowl Auto Filling by Dogbert Thingiverse
Dogbert shared this project on Thingiverse!

This was the ULTIMATE Gag-Gift for a family member who has a new German Shepherd!

From the original Potty Bank (Thankyou 3dPrintingWorld for the original design!):
I scaled it up 315%
Then used Meshmixer to subtract a 90mm cylinder from where the coin slot is, to accept a standard 1.25lt water/soda bottle.
Smoothed using Meshmixer.

Also made two bottle adapters – one to have the water level at the lower lip, and one for the water mid-way up the lip.
Then made the lid pin.

Download files: https://www.thingiverse.com/thing:4900457


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

No comments:

Post a Comment